05 Industry
District heating network monitoring
Substations already come fitted for M-Bus remote reading. NeMo reads all of them and shows where the network loses heat and where the temperature drop does not add up.
Illustrative figures.
What NeMo reads
The quantities that matter
The energy leaving the plant and the energy metered at the users never match, and without continuous reading the difference stays a year-end figure nobody can explain.
Energy per substation
Read from the meter already installed: remote reading on heat meters is nearly always fitted and never used.
Supply and return
Flow and temperatures on both sides, the quantities everything else is derived from.
Temperature drop per user
The actual one, not the design one: it is the number that says whether the network is running for nothing.
Plant room
Generator output and power draw, to tie what goes in to what is delivered.
Pressures and levels
Along the network, where a leak announces itself long before it becomes a callout.
How it connects
It speaks your field’s language
Meters, analysers, controllers and probes: the node connects to what is already installed, over the protocol it already speaks. Nothing in the field is replaced to get started.
Powered on and already talking — self-configuring in the fieldWhat comes out
From the reading to the decision
Network losses
Continuously rather than at year end, with the stretch where the balance stops closing.
Substations to revisit
The ones with a low temperature drop: they circulate flow without giving up heat, and the whole network pays.
Metering
Per-user consumption ready for billing, without the reading round.
Load curves
By season and by time band, to tune production against rather than chase it.
Nearby industries
They usually come together
Start from your plants
A 30-minute technical call to go through what you already measure, what you do not, and what it would take to close the gap.